WELDER IMPORTANT NIMI BASED MCQ

When does the defect of gouging on cutting face takes place?
A. Too much pre-heating
B. Too slow cutting speed
C. Excessive speed, inadequate pre- heating
D. Too much cutting oxygen pressure

What method of heating is done to remove bending distortion of weld joint with wedge shaped area?
A. Spot heating
B. Pipe – needle heating
C. Triangular heating
D. Checker – board heating

What is the purpose of inspection in welding?
A. Determine faults and quality weld
B. Determine the material
C. Determine the welded metal
D. Determine the electrode fusibility

How many stages are there in visual inspection in NDT?
A. Two stages
B. Three stages
C. Four stages
D. Five stages

Which type of test is generally not used on the final product?
A. Non-destructive test
B. Semi destructive test
C. Destructive test
D. Non destructive & semi destructive

What are the common welding tests performed in workshop?
A. Nick break, free bend, fracture
B. Tensile test
C. Guided bend test
D. Impact and particle test

How many types of common non destructive test are there?
A. 2 types
B. 3 types
C. 4 types
D. 5 types

What type of test is visual inspection test?
A. Non-destructive test
B. Destructive test
C. Non-destructive and destructive
D. Performance test

What is the NDT method using sound as a source?
A. Visual inspection
B. Pressure test
C. Stethoscopic test
D. Magnetic particle test

What activities contribute to the fabrication cost?
A. Preparation, welding, finishing
B. Raw metal, welding, finishing
C. Welding, finishing, transportation
D. Finishing, transportation, marketing

What is the test in which the weld quality is tested without destroying the job?
A. Destructive test
B. Non-destructive test
C. Semi-destructive test
D. Visual inspection test

Which stage the root gap is set in welding process?
A. Before welding stage
B. During welding stage
C. After welding stage
D. Finishing welding stage

Where do we cut 2.0 mm depth by hand saw to conduct Nick-break test?
A. Cut to base metal
B. Cut along centre line of weld
C. Cut to weld metal and base metal
D. Don’t cut to metal

Which is a non destructive test?
A. Without damaging the job
B. With damaging and with distracting
C. Nick break test
D. Free bend test

The welding cost estimation of power cost is (V x A/1000) x (T/60) x (1/E) x rate per unit is formula. What is the ‘E’ identify?
A. Electrode consumed
B. Electrode of weld metal
C. Efficiency of machines
D. Efficiency of weld meter

What is the cost, involving office expenses, lighting, rent etc but not directly related to the job?
A. Power cost
B. Labour cost
C. Finishing cost
D. Over head cost

What is the test to find weld defect using sound waves echo displayed on calibrated screen?
A. Stethoscopic test
B. Radiographic test
C. Ultrasonic test
D. Liquid penetration test

What is the test if the weld specimen is placed in between the x-ray unit and film?
A. Ultra sound test
B. Radiographic test
C. Magnetic particle test
D. Liquid penetrant test

What are the costs involved in welding job?
A. Electrode, power, labour
B. Material and machining
C. Material and preparation
D. Proportion cost and works cost

What type of safety equipment is worn while checking the welding joint of a overhead crane frame?
A. Apron
B. Helmet
C. Hand gloves
D. Hand screen